AMD: Our Next Generation (Arctic Islands) GPUs will offer Double the Performance Per Watt of the Current Generation

Usman Pirzada

It looks like the GPUs in 2016 are going to be a major step up from current gen, because we keep on hearing about performance basically doubling, thanks to the transition to the smaller node. There have been reports in the past about Nvidia's Pascal having 17 Billion transistors (more than twice as many as the Maxwell flasghip) and even now at AMD's earnings call, Lisa Su stated that the next generation AMD graphic cards will double the performance per watt delivered by the current generation (Fiji) lineup.

AMD Arctic Islands R9 400 SeriesNot an official poster. @Wccftech

AMD's Arctic Islands lineup will offer atleast 'double the performance per watt' of Fiji processors

While it has been implied in the past that the performance jump is going to be enormous, this is one of the few times where the company has explicitly mentioned just how big the jump is going to be. Lisa Su made the following statement on the recently held earnings call for the results of the third quarter, year ended 2015:

"We are also focused on delivering our next generation GPUs in 2016 which is going to improve performance per watt by two times compared to our current offerings, based on design and architectural enhancements as well as advanced FinFET products process technology." - Lisa Su, AMD

The alleged codename of the Arctic Islands' flagship is 'Greenland' and if what AMD says is true (and there is no reason for it to not be just that) we are looking at a 100% increase in performance over Fiji. But just what exactly does that translate to in terms of numbers? Using what we know about the FinFET process, we can arrive at a tentative answer. 

While Nvidia is confirmed to be on the 16nm FinFET+ node from TSMC, the same cannot be said about AMD. We do however, have more authentic reports about AMD being on the 16FF+ node as opposed to 14nm FinFET. So if we are to assume that the same is true for AMD, then it is going to adhere to the same rules as Nvidia's next process. Here is an official summary of the 16FF+ node from TSMC official:

TSMC's 16FF+ (FinFET Plus) technology can provide above 65 percent higher speed, around 2 times the density, or 70 percent less power than its 28HPM technology. Comparing with 20SoC technology, 16FF+ provides extra 40% higher speed and 60% power saving. By leveraging the experience of 20SoC technology, TSMC 16FF+ shares the same metal backend process in order to quickly improve yield and demonstrate process maturity for time-to-market value.

Fiji GPU has a total of 4096 stream processors and 8.9 Billion transistors and the die size is 596mm^2. So for double the performance, we are looking around 18 Billion transistors for the Greenland (Arctic Islands) chip. Ofcourse, if the die size is ~500mm^2 initially then anything in the range of 15 Billion transistors goes. For the ~500mm assumption, after accounting for performance increases via architectural improvements, a gain of 66%+ (anything between 70-80% realistically) can be expected. While that is not a full 100%, it is close enough. Ofcourse we have no idea what the stream processor size will be, so attempting to reverse engineer the exact core count would be an exercise in futility. It is a safe bet however that the number would be somewhere around the 8192 mark for a ~600mm die or around the 6784 mark for the ~500mm die (plus minus a few multiples of 128).

The GM200 on the other hand, has 8 Billion transistors, so double the density would yield around 16 Billion transistors for a ~600mm chip according to TSMC specs assuming the transistor specifications remain the same. If we are to assume a ~500mm^2 chip for the initial 16nm FinFET+ run then the transistor count would be roughly 14 Billion transistors. If the rumor about Nvidia bringing 17 Billion transistors to the table is true, then either TSMC can manage a ~600mm^2 chip right off the bat, or, Nvidia's next generation Pascal GPUs will have a new transistor-to-core ratio and design (improbable).

While the fact that TSMC is using the 20nm back end process helps in the claims of a ~600mm^2 die, I myself,  have difficulty believing that these companies will launch with such huge dies. It is possible that competition might force them to do so, but in my opinion, the probability of an initial ~500mm^2 die is much greater. At any rate, we are going to have an absolutely amazing showdown in 2016, with the first full fledged, 4K @60fps monsters landing in the DirectX 12 arena. It is most definitely a good time to be a PC gamer. 

Share this story

Deal of the Day

Comments